IZOZENĀ® FLEXPRO SEAL 100
IZOZENĀ® FLEXPRO SEAL 100 is a two-component, flexible, brushable waterproofing slurry.
It consists of:
Component A: Cement-based powder mortar
Component B: Acrylic resin
Once hardened, it forms a seamless, jointless membrane with excellent waterproofing and protective properties.
Key Benefits
Crack-bridging ability
Waterproofing against positive hydrostatic pressure (up to 5 atm, EN 12390-8) and negative pressure
Vapor permeability
Safe for potable water tanks (W-347 certified) and food contact surfaces
Protects concrete from carbonation and corrosion
Resistant to sewage water and aging
Bonds to slightly damp surfaces without primer
Simple, low-cost application
Suitable for green roofs, flower beds, swimming pools, flat roofs, and basements
Acts as a radon barrier
Technical data
Form: Cementitious co-polymers
Colors: Grey / White / RAL 7621, 5002
Water Demand: 1.00 ā 2.00 L/Kit
Application Temperature: +5Ā°C to +35Ā°C
Mixing Time: 3ā5 minutes
Pot Life: ~60 min (+23Ā°C)
Minimum Thickness: ~1 mm
Crack Bridging (at +23Ā°C): ā„ 1.13 mm
Bulk Density (Dry Mortar): 1.40 Ā± 0.05 kg/L
Bulk Density (Fresh Mortar): 1.70 Ā± 0.1 kg/L
Initial Tensile Adhesion Strength: ā„ 0.7 N/mmĀ²
Tensile Adhesion After Water Contact: ā„ 0.6 N/mmĀ²
Durability: Resistant to aging, moisture, and water pressure
Resistance to Water Pressure: Positive pressure after 3 days; negative pressure after 7 days
Directions for Use
Mix 15 kg Component A with 5 L Component B under continuous stirring until smooth, viscous paste forms.
Pre-wet the substrate to a saturated surface-dry condition.
Apply by brush in two or more coats depending on water load.
Avoid coats thicker than 1 mm (may cause cracking).
Apply each new coat only after the previous one has dried.
Protect freshly coated surface from rain, frost, or high heat.
For reinforcement at corners or junctions: use 10 cm fiberglass mesh strip (65 g/mĀ²).
Fields of Application
Concrete, plaster, brick, cement block, terrazzo, gypsum board, wood, metal
Areas requiring high flexibility and adhesion under expansion, contraction, or vibration
Waterproofing for:
Flat roofs and balconies
Above-ground water tanks and swimming pools
Inverted roofs
Basements (internal or external)
Surfaces exposed to moisture or hydrostatic pressure